Another GT4 Clubsport through the shop, another livery built for the track. This one runs orange and charcoal grey in a large checker and geometric pattern, with bold “BR” logo placement on the doors and quarter panels. The result is aggressive without being busy.

The Livery

The design uses oversized checker blocks across the rear quarters and doors, breaking into angular geometric shapes toward the front. Orange does the heavy lifting on the mid-section and rear, with the grey base letting the orange read at full intensity. The “BR” logo anchors each side cleanly.

On a wide-body GT4 Clubsport with a full GT wing, the livery has a lot of surface area to work with. The panel transitions and aero elements all had to be worked into the layout intentionally so the design flows across the car rather than stopping at body lines.

Material

The full livery was installed using 3M IJ175cv3 cast film with 3M 8518 overlaminate throughout. Cast film is the only sensible choice on a competition car. It handles complex curves without memory, and the 8518 overlaminate protects the finish for a full race season.

AZ Rag is a 3M Preferred Installer — certified and experienced specifically on competition vehicles.

More GT4 Clubsport Work

The GT4 Clubsport is one of the more frequent cars through our doors. Each livery is built from scratch for the team and the look they want. If you want to see the range of what we have done on these cars, take a look at the green and black Flatrock race livery, the chrome gold two-layer Flatrock build, and the Phillips GT4 RS Clubsport livery.